Posted by Angle Iron on January 05, 2017 at 15:29:59 from (73.131.52.171):
In Reply to: sick world posted by Mike(NEOhio) on January 05, 2017 at 11:02:06:
Quoting Removed, click Modern View to seeThis should be a hard situation to get out of. Four black kids kidnapped, beat, tortured and loaded a white mentally challenged white kid into a stolen van kept him over night and called his parents asking for a $300.00 ransom. Not much money but ask for but a dollar or a million doesn't matter its still a ransom. The blurry video on the news shows one of the four with a knife. All this as they were using racial slurs and others slurs as I understand connected to his mental disability. The knife is a deadly weapon by all standards so attempted murder would not be a stretch. I can not think that this should be less than a life sentence for the four of them. That may seem harsh, I would think that this could be a death penalty case considering the double hate crime with a deadly weapon but the liberals would have a fit. In many cases in the past whites have done things just as bad or worse and now we have this hate crime thing to cling to as well. This needs to be pursued as the terrible crime that it is and they should suffer the consequences. By the way I think charging some one with a hate crime is a joke and very hard to prove. How do you prove what they were thinking unless they tell you. How many will tell you the truth? These kids have been raised in a society where they are never at fault for what they have done its always some one else's fault. The authorities statement so far was this was just some stupid kids doing stupid things. I think that the kids are not the only stupid ones.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
