Dave not if you have an air floor. All of my bins do. The air floor is bolted about 12-18 inches above the bottom of the first side sheet of the bin. The auger goes under the air floor and has a hopper up through the air floor. Look at the picture and you can see how they are done. The sweep auger can be of two types some of the more modern one stay in the bin until you have it emptied down to the cone. All of mine the sweep auger comes out and is installed after you have the grain down to the cone.
If you do not have a full air floor then the unloading auger can be in the base concrete. I do not like those type of bins you just about always have spoilage against the concrete. Even the ones with air troughs in the floor still have spoilage.
It sounds like you want to be able to dry corn in the bin. So you will want a full air floor. Whether you have a fan with heat or not you still want a full air floor.
Second picture shows an air floor part way installed. There are many types of floor supports. The one in the picture has straight runs. I have never seen those type in person. The older bins used concrete blocks stacks. The newer bins use a steel stamped floor brace that are set in alternating rows under the air floor ( 3rd pic).
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
