Posted by marcusoverholtzer on November 28, 2016 at 08:24:32 from (216.14.246.61):
In Reply to: Re: John Deere 4020 posted by 2510Paul on November 26, 2016 at 15:58:22:
Hello all again. Just so you know Im new to this and plan to start a little side farmaing with the tractor. It runs well but is in bad cosmetic shape. The engine was rebuilt under 500 hours ago according to the guy a bought it from and the it sat for several years. Thank you lots for the list 2510Paul and Ray Tractor. These lists look great and will definatly use them. As far as i can tell there is know big mechanical problems with it. It still has the factory 24 volt system wich I plan to convert to 12 volt. The main reason I asked for this list is because I want to go through the whole thing and make sure it i8s ready to go and free of trouble before it gos to the feild. I also plan to paint it. My three point does settle I belieive someone asked about that. How would you fix it? ALsso my pto turns constantly and I was told to check the linkage and that looked good but when i pull the pto lever back hard the shaft slows down a bit. Idk for sure what that means maybe someone could hep me with that? Thanks everyone for your help!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.