Posted by Case Nutty 1660 on November 05, 2016 at 05:12:34 from (75.127.24.87):
I like many Farmers and Ranchers alike do things by myself,, I just did a "set-back" of a set of swinging gates yesterday, a first for me,, I think it turned out pretty nice,, the County had built this new by-pass road about 4 years ago,, the contractor who installed the fence did a shoddy job to say the least,, they claimed to have set the corner and gate posts 4' deep,, Yea Right, more like 2 1/2 feet at best,, they were leaning after less than a week,, the gate posts I set are 10 1/2 feet long 9" plus posts,, they are just over four feet deep,, and all hand tamped rather than drove in,, only way to set posts like this in my mind,, anyway this will let us get off the busy roadway to open the gates we have had a few close calls already, I moved the gates in 32 feet by the way cnt
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
