Posted by nrowles on November 04, 2016 at 11:36:47 from (71.251.155.138):
I am putting a wood stove in my 30x40 garage and would like to get any input. At this point I am new to this and will eventually get instruction from family and friends that burn wood. My question is, should I go thru the wall or thru the roof, or doesn't it matter? Going thru the wall seems easier to install and clean but costs about $225 more. Taking the cost out, is either one better than the other? How do I clean the pipe prior to the cleanout?
It says I need to have the top of chimney at least 2' above anything within 10' so that's what I did.
First image is thru the wall. Starting at the stove there is a heat shield behind, from top of stove there is an 8" to 6" reducer needed for my stove, damper, 4' single wall pipe, 90 degree pipe, single wall to triple wall adapter, 2' pipe thru wall thimble, tee with bottom cleanout sitting on top of support bracket that has a one foot extension to left, chimney pipe up with a couple brackets and chimney cap.
Next image is thru the roof. I'm not exactly sure how to get the pipe connected to the pieces going through the roof so my lengths might be off. Also has the heat shield, 8" to 6" reducer, damper, 5' single wall pipe, single wall to triple wall adapter, pipe going through the kit in the roof including a "box", heat shields, flashings, etc., and a mounting bracket and chimney cap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
