The only running on choke does sound like a fuel problem. There is a drain plug in the bottom of the carb. With the fuel valve on, pull the plug, catch what comes out in a clean glass. It should start as a full stream, then slow to a trickle. If it slows to a drip or stops, there is a fuel restriction. Could be at the tank, there may be a screen at the inlet fitting of the carb, could be the float stuck. Those carbs are simple, field serviceable, can usually be eased apart without needing a kit.
Look at what you caught in the glass. If it's dirty, or has water on the bottom, the tank may need to be dumped and carefully rinsed out. At that age, expect some rust, so be gentle or it will be leaking.
The grease on the bearing appears to be coming from the spindle bushings. That's normal, but there should not be excess play. It may need spindle bushings and/or spindles.
A shop manual would be a wise investment. It will more than pay for itself in mistakes not made!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.