Posted by all_atv82 on October 13, 2016 at 05:28:36 from (207.199.193.162):
Just thought I'd say hi, I'm Ryan, in Iowa. I just bought my first tractor a 1960 Ford 801 powermaster with a woods brush cutter for $2500 (2 hour away delivery to my house also included). I hope I did ok on that price, it has a few issues I will try to figure out with the search function here before I post much.
Should I post questions about this tractor in the 8N/9N section or the Ford section?
Issues I've found so far are that it will only run on full choke, the guy said once it warms up it is better. But no better so far. Hopefully just a fuel issue, or rebuild carb.
One rear rim is rusted a bunch, other a little. Still hold air but barely I'm sure. Brand new rim is $200 so not bad, but may try to find a used one.
One front bearing is likley bad, has a whole bunch of slop and grease coming out of it, and wobbles when I shake the wheel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.