Posted by larry@stinescorner on September 06, 2016 at 15:20:59 from (74.105.174.208):
A friend gave me this,he said it will keep Bruce from Canadas Geese away from the pond? Its time to shape up the gardens,and try the tiller that a friend gave us,it hadnt run in ten years It tills good,starting to run better the late plants came up,even though its dry the late beets,,not sure if they will make it before frost,,we will see the pumpkIn seeds were planted in some spots after we dug potatoes some white pumpkins too and a few neck pumpkins some late cucumbers where potatoes were dug,,and I found a few that we missed while tilling a small seeding of white lady turnips,a special mild turnip,in a spot where we had dug potatoes earlier some more beets the early girl tomatoes are still producing the late lettuce is starting to look better .now that its not so hot the sunfloweras are not as pretty,but are getting bigger,,,tweety birds are flying in and out all day what kind of nut would plant this in a blank spot amongts the sunflowers? And of course,,my favorite lunch,,,,///////Thanks for spending time with us in PA!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.