That is a tough situation. Things in his favor include: 1) You have some kind of relationship. 2) Sounds like you probably have made some money off of him. 3) The repairs took longer than intended 4) You didn't know that he was mowing another lawn nor did you specify what he could mow, and 5) he has actually told you about the hood damage. I guess I would collect the repair bill on the overturned mower. Then either he will mention the damage to the loaner or you will have to bring it up. He may primarily only recall the hood. I guess you are going to have to mention the gauge wheel and the scratches. You might have to remind him that the agreement was for him to cover any damages. Can the hood be repaired at a body shop with fiberglass?? Straighten and weld if necessary the gauge wheel. Sounds like the mower might be for resale??? I guess I would sand out the scratches and repaint. Move it - get it sight and mind. Fixed back up you will get all of your money back especially if he covers the primary expense - the hood. Straightening the wheel and repainting the fenders doesn't have to cost that much. Like you said the engine rebuild took much longer than ever expected. This was out of his control. Everyday you will feel better. Eventually you will get to the point where you will be glad that you didn't blow up and cause a fight. Certainly, yes, he should pay you for reasonable expenses incurred in bringing the loaner back to prior condition. Like you said ....you are just going to have bite the bullet on this and move forward. I am sure I would feel the same way.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
