There was quite a bit of discussion about pulling things with a tractor in another post here recently. But bottom line is, never, ever ever pull from any point above the axle. I have a 9N and an 8N. The 9 has a draw bar that attaches at to the lower three point hitch arms with stay bars running up to the top link attachment point and sway bars to brackets under the fenders. The 8N has a dedicated draw bar that runs under the "pumpkin" and stays on the tractor for most uses (if I recall it has to come off when the brush hog is used). I'm not familiar with the Fergy but it would use either of these systems, probably the 3 pt. bar. If pulling a log or anything for that matter, make sure the front of it is off the ground. Should it dig in you could get a nasty jolt, break something, or worse, a back flip of the tractor. It would happen so fast you'd be dead in a second.
Similar issue with running on hillsides, creek banks, ditches... you can flip it over on yourself if not careful.
As far as the PTO shaft, never, ever, ever go near it until it has completely stopped turning, especially on a brush hog, lots of momentum in those blades. It can grab you and pull a limb off or suck you in to severe injury or your death.
Oh, and NO riders! How horrible to see your kid or grand kid slip off and disappear under a wheel or under the brush hog, you'd never get stopped in time.
Properly used these old tractors can be reasonably safe and productive for you, but use your head.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
