Posted by bingo71 on May 07, 2016 at 21:21:15 from (107.77.104.120):
I sold my 1952 8n fordtractor to a 85 yr, old gentlemen from Randof Ms. He called early Wed. AM said his engine had just blown in his 601 and he needed to plow today.HE LOOKED THE LITTLE N OVER. HEARD IT RUN, SAID HE WANTED IT.,DIDN'T BRING AN MONEY, SAID HE WOUOLD BE BACK WITH MONEY, TRAILER. hEOME RIGHT THEN CALLED ME tHUR. SAID HE HAD FOUND HIS TRAILER AND HE COULD COULD COME RIGHT THEN, TOLD HIM TO COME ON, GOT HERE LOADED READY TO GO, PD. ME CASH .. hE WANTS TO SELL ME HIS BLOWED UP 601 ONE NEW REAR TIRE, OTHER 3 WORE PRETTY BAD, LIFT HANDLES ROUND BALES OK I DON'T KNOW WHAT TO OFFER HIM SIGHT UN SEEN.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
