Posted by bobinsd on March 28, 2016 at 14:18:16 from (137.216.208.116):
Figured maybe I'd tap some of the wisdom here. Had a new drainfield installed in '07. I don't believe they did anything with the septic tank, but it looked good.
In '12 the drainfield "settled", sinking down about 8' to a foot over each pipe. Didn't see any problems till the end of this past summer. About August doing 2-3 loads of wash in a short time caused an overflow into the basement (tank full up into the riser). Had the tank pumped out and supposedly inspected, didn't seem to dirty (I think it had been 5 years since the last pumping, but we're on a well and don't normally use it real hard) and the tank supposedly looked fine.
The ground is really wet right now, but yesterday one load of wash followed by a shower caused overflow again. With very little use it was down a few inches below the riser (whatever, the round access tube that comes up to ground level) even after a few very quick showers this am (water on, wet down, water off, soap, water on rinse--mine didn't really even get warm)
Any suggestions on what to look for or what to try next? I'm guessing we'll need a new drainfield again. Ideas? Even ideas on what to ask the local experts (assuming I can find any). There a a couple of companies that pump, and some companies that dig/install, but nobody to really say "hey, you need to ....".
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
