Thanks everybody. That's more than I can digest and respond to all at once. I'll probably be back with more questions once I chase down the info and links you've provided.
I did fill in over the settled trenches, and water does not sit there (one of the few places that actually slopes a little in my yard). Ground water is very high around here, digging 2-3 feet deep normally gets muddy (depending on the time of year, there is standing water in many fields now).
I'm going to run the washer and maybe the water softener out somewhere other than the septic for the short term, to buy some time to find an expert and get a better system designed.
Thanks especially for the link to the code. It's pretty general, but doesn't seem to allow the "gravel-less tile" the last guy put in. I'm also unsure if the drain tile around the footings goes into the septic. I would hope it doesn't, but I can't find anywhere else it comes out either. One of the down spouts went into that drain tile when I moved in, but I routed that out into the yard years ago. The water softener goes to the floor drains in the basement, which I now know go to the septic tank. I suspect that the salt is hard on the drainfield so I'm trying to figure a short term plan to send that out a basement window and far enough to get to the gravel barnyard (and away from my trees) as well as a longer term plan to send that elsewhere so as to not ruin a new drainfield if/when I go that route.
Does anybody have an expert to recommend in eastern south dakota or south-western minnesota?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
