Posted by notjustair on March 13, 2016 at 19:36:49 from (70.195.5.204):
As I've gotten older I've realized that there are certain situations where going to the dealership for a real part is necessary. It usually just means doing it once as opposed to doing it again in six months and then finding out the part that should have worked fine also wrecked what was still a good part of the machine.
I have a friend and his father whom are willing to rig up anything. They always have the best of intentions but are stuck thinking that corn picker they shoved in the tree row 15 years ago stil only needs that one chain. They have a few acres but fired their renter so they are going to "farm".
I was talking with them yesterday and his father was talking about a bearing that had gone out on his disk. This would be the same disk that he welded a shattered disk blade on last week (those may not be cheap but I just keep a couple on hand). Well, they still make that roller bearing but it is $200. He found that if he cut 17 pieces of a 7/16 bolt they fit in there. I'm as frugal as the next guy, but sawing 17 pieces of bolt would have just undone me. I believe I would have just replaced the beating grumbling all the way.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
