Worst smelling the final drive on a D7 that had been working in a dairy barn. The combination of 90W gear oil, and cow #1 and #2 made for quite an odor on a 90 degree plus day.
The cleanest, and best smelling was repairing a laundry machine in an area hospital. I had to fabricate a shaft, and a mount, and mount it all on the machine. This was to replace one that had originally been mounted into a machined place on a cast iron frame, after it spun, due to lack of grease, and damaged the frame beyond economical repair.
Tightest place to work, was inside a hydraulic, telescoping boom on a truck crane. I had just enough room to lay back over the winch, and slide in under the extension cylinder. Once in place I could rotate my body just enough to work with one hand and get the hydraulic line back on the 'monkey' that carried it inside the boom. Only took me two days.....
The highest places have been was a job helping mount an antenna 230 feet up on a water tower, and a line boring job about 100 feet up on a portal crane.
The lowest would be around 300 feet plus down in a quarry working on a crane being used to dropball oversized rocks.
The worst I just did. It was going behind someone who had no clue what he was doing to get the hydraulic system he screwed up right again. It's the first time I have ever gotten completely frustrated doing a job and just had to quit, several times, to keep myself 'sane'.
The wide variety of places and jobs is one of the things I love about my job.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
