I get the same feeling about the machines at work, the CNC mills and lathes. I have no clue how to run one, but I can sure crash one! At the same time, the guys that run them have little success operating a Bridgeport or conventional lathe. Without close supervision, they will break tools, get themselves in a position to get hurt!
Seems it's a generational thing. Take the farmer that was uncomfortable switching from horses to tractors. He used what he knew. Felt right at home with horses, scared of tractors. I would have no clue how to raise, train, rig, or use a horse or mule! Frankly, they scare the daylights out of me! But I would not be afraid to figure out how to operate a tractor I was unfamiliar with. At least it will stop when I tell it to!
As far as the sophisticated electronics on the new equipment, us lay people are not intended to repair that stuff! It is constantly changing, intentionally designed with proprietary schematics, and requires special diagnostic equipment that is priced beyond the economic feasibility of the DIY'er. I hate that too, can't stand to have to subject myself to a shop that has the "we gotcha right where we want you" mentality!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
