Posted by JF in CT on February 11, 2016 at 08:19:42 from (67.133.144.210):
In Reply to: Jobs going to Mexico? posted by Spook on February 11, 2016 at 07:55:44:
I tend to agree with you but saving labor costs by moving outside the US is not the only method. As happened in my company years back and a friend's company (both very huge corporations) they announce that they are closing up a facility and that jobs will only be available at "such and such" facility several states away but you will have to 're-apply'. Long time staff, who are too well entrenched in their home state (i.e. can't afford to sell or move without a crippling financial loss) quit or take a small buyout. After the staff is reduced, mostly by those who earn "too much" for their position (because all the years they got 'cost of living' raises that compound off their base) the company calls off the move (for some contrived reason) and hires new people at a lower pay scale. Better yet (as happened to a good friend) they hire back the same person for the same job at half the original pay. Then the cycle, maybe 10 or 20 years, starts all over.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
