Posted by Billy NY on January 05, 2016 at 11:55:10 from (104.228.35.235):
In Reply to: Barn Roofing question posted by Brad Gyde on January 05, 2016 at 10:48:33:
If you can match them up again, restore the seam to what it was, it should work. Fasteners and their holes are the weak area, so you may want to look at using new locations so you have a good connection, sealing the the old ones permanently. Not knowing the materials, its hard to comment on sealants, being metal, silicone is usually a good choice to seal fastener heads, even as part of a patch to seal off any old fastener holes with say a small piece of metal as a cover, then seal around that. It usually achieves a good bond, is elastic and won't be compromised for a long time and its compatible with itself. A bituminous, (asphalt) sealant like for roof repairs, in my opinion is more problematic over time, it is not as elastic and it is not compatible with silicone, so once applied, you usually have to stay with it. Check to see if this roof has been painted with the silver roof coating/paint, that would be an asphalt based product and you may not get silicon to bond to it. It sounds like you have a good handle on this and you are very wise to get the repair done immediately, so many over the years did not and the barns succumb to it eventually.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let�s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
