Posted by 806man on December 05, 2015 at 12:41:23 from (72.22.113.231):
In Reply to: Cattle Know What to Do posted by Andy Martin on December 05, 2015 at 12:11:41:
Good comment about them knowing what to do. I have 2 cows now that I bought as 500# heifers about 7 years ago that were kinda skiddish when I got them. Each time that I get them up to work them or whatever it is always at least a month before they will both come back into the barn lot and corral where I feed them. Last time in the chute was on November 17th. One has somewhat started to come around but the other is still standing back, way back. She will eventually come back in but really never forgets that alley and head catcher. I must admit that while she is in the chute she does get some extra attention that she really does not approve. I am never rough with my cattle and all of the rest of my cattle are born and raised here on my place. Those will go back into the corral the next feeding. They are not all dumb animals. Some of them have a memory like an elephant and really never forget.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.