Posted by mjbiddle on November 12, 2015 at 18:31:24 from (107.147.200.173):
641 turns over okay. Watched a youtube video on diagnosis and said to connect test light to distributor terminal as first check. I get a solid light which is good. Second test is to do same thing but this time crank engine. Test light is supposed to flash with the points open/close. But I still get solid light with this test. Video said that this means bad points. So I bought new Blue Streak points and condensor and get same results.
Another thing that I did when I put the new points/condensor/rotor was to replace the broken flat copper wire inside the distributor that goes from points to distributor terminal (then out to the coil). I thought maybe that gasket may have gotten damaged during the install so I put in a round fiber gasket there (in addition to the original) to insure no contact. Did not matter.
Tractor was running before the carb rebuild and new ignition kit. Third step in video is to check spark but that was predicated on passing step two - which I have not.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
