Posted by super99 on November 03, 2015 at 17:42:41 from (74.32.240.165):
I bought a White 2-62 loader and backhoe a while back and am finally getting time to work on it. So far, I only replaced a hose on the backhoe for $48. The cylinder for the bucket is leaking a steady stream of oil out of the top of the cylinder from the tube that carries oil to the bottom end of the cylinder. The tube appears to have a bend in it, PO must have hit something with it. The book says there is an o-ring and washer on each end plus a spring on the top end. I'm guessing you have to push tube against spring to get it out of the bottom end to replace the O-rings. Any ideas on getting the tube to move against the spring? Vise grips and a hammer come to mind, any better suggestions? Can a small bend it the tube cause it to leak around the o-ring? Can you buy new steel tube and make a new one if necessary? Any help or guidance appreciated. Chris
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
