Posted by paul on October 29, 2015 at 08:14:53 from (76.77.197.114):
In Reply to: JD hydraulic tips posted by 4520BW on October 29, 2015 at 07:49:50:
New hose all the way, or an adaptor from the bigger o ring hose to the more standard 3/4 pipe thread of most ag quick couplers.
I run into odd stuff on my auction purchases too, ended up a disk I brought home was 3/4 inch o ring hose ends, just never see that here. Went to the auto and bearing supply store they have a great hydralic hose guy there, didn't even get to him the counter guy said oh, we have run into that, don't we have a box of ISO O ring tips in back? And he and the other counter guy brought me 4 ends, didnt need any adapters.
Gets depressing to run into all the different 'standard' hyd sizes can't keep up down on the farm, and the farm supply stores stock 2 of all the different possibilities, typically someone buys one and you are left short when you need something....
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.