Posted by perryjosh64 on August 29, 2015 at 21:55:40 from (50.96.86.67):
Folks I'm new to the forum as well as owning my own tractor as of today. Prior to buying a 1964 Ford 2000 the seller told me up front the clutched seemed to be a little "sticky" but thought it would loosen up with use as the tractor had sat up for awhile but did say I may have to replace it if it didn't. My questions are;
A) Is it difficult/complicated to replace a clutch?
B) How do I tell if mine has a "overrunning clutch"?
C) If/when I replace clutch can I put in an overrun clutch if it does not have one or could I put in a two stage clutch/live PTO?
I've driven tractors often but no very little to their detailed workings so any and all advise will be appreciated and using simple terms won't hurt my feelings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
