Posted by fixerupper on July 29, 2015 at 06:28:08 from (100.42.82.100):
In Reply to: smoothing out a yard posted by Nick167 on July 28, 2015 at 13:23:43:
I smoothed my lightly rough lawn by rolling with a heavy roller, 6000 pounds over a five foot width. Couldn't hardly tell a difference till I had rolled it every spring for three years or so. Now after ten years it is smooth as a baby's butt. This does not work for deep ruts, they have to be filled in first, then rolled. If the lawn is to be torn up, leveled and reseeded the best way, though it is a long drug out process is to kill it with Roundup in the spring, let it lay dead till August when you work it down till the soil is fine powder, then seed in early September and pray for rain. This works in Northwest Iowa, don't know how it would work in your area. If no rain in the fall, a half stand will come up next spring. It is a little bit of a gamble.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
