Posted by tvscum on July 25, 2015 at 21:09:04 from (66.75.55.78):
How do I wire this OFF DIM ON switch to be an OFF/ON headlamp and tail lamp switch only? 6v positive ground system on a 1926 Gotfredson farm truck.
My generator does not have a Field terminal, so I do not need to use this switch for a generator output resistor.
Here is the front of the assembly. (The missing gauge is oil pressure).
Left:
Right:
And the back:
The headlamp gauge has screws marked BAT, REAR, ON, LHD, and a mystery label I cannot make out:
To use this switch as a ON/OFF only, do I simply wire the negative battery lead to BAT, the rear tail light to REAR, and the headlamps to ON? And, ignore the LHD and mystery screw?
There also is that cab light on the front of the assembly to light the interior.
Thanks in advance!
This post was edited by tvscum at 21:12:55 07/25/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
