1.Measure the diameter of the piston. As an example, a piston has a diameter of 5 inches.
2.Square the diameter, multiply it by 3.14 and divide the result by 4 to calculate the area of the piston. In the example, squaring the diameter of the piston gives you 25, multiply 25 by 3.14 gives you 78.5 and dividing 78.5 by 4 gives you 19.625 inches squared.
3.Multiply the piston's area by the splitter's pressure rating. In the example, the splitter has a pressure rating of 3,000 pounds per square inch (PSI). Multiplying 19.625 by 3,000 gives you 58,875. The log splitter has a splitting force of 58,875 lbs..
The numbers are just an example,not what we are using. It will give you a tonnage of the splitter.
The reason for having a high ton rate is it is better to have it and not need it,than to need it and not have it.We like having extra hyd fluid for a cooler running system,not like the homeowners versions people can buy at local stores, most are only 3 to 5 gallon of fluid capacity and are always running hot after the first hour,seals,bearings, really take a beating on the pump and cylinder,causing leaks and pump failure,valve leakage,so having extra fluid takes longer to heat up to high temps.
link is to a 50 ton splitter from Amazon,so you can see the specs for it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
