Posted by Bryce Frazier on June 26, 2015 at 17:43:56 from (67.142.182.21):
Well, I got my 1 way cylinder on the IH 990 swather. I got the line modified to fit the tractor. I got the remote line put ON the tractor. EVERYTHING is in good working order.
I hooked it all up just now to give it a go, and it don't have enough snort to pick up the header..... I FINALLY messed around with it, and got the "transport pin" out of it, so the whole weight of the header was on the cylinder. Held it up just fine, and I let it about half way down, wouldn't go up, so I thought, well, might as well go ALL the way down, so I did.
It easily picks the header up so there is about 6-7 inches of clearance between the sickle and the ground. Which, I suppose is good enough for using, but I would like it to work properly, SO, is my belly pump worn out, just that weak to start with, what?
It has an odd looking purple fluid in it, that is VERY clean/nice looking. Actually drained it all out, and decided to put it back in!
I think it might be a LITTLE thinner that "normal" stuff, but it is close to 100 out there today. Should I try putting 90W in it and see if that helps?
What are my options? What can I do to make it work better?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
