Re: Re: 9n gaskets

Posted by michael on August 22, 1998 at 21:41:31:

In Reply to: Re: 9n gaskets posted by Gary H. on August 22, 1998 at 20:41:13:

: : i am rebuilding the motor on a 44 9 N (2n) in the gasket kit was included 8 rubber washers 1 1/16" diameter 3/16" thick and have a center hole 11/16" since there are 8 i assume they are part of the valve train but i dont know where they go

: These are the seals that go on the valve guides. Not sure about the usage on your 9n. Do you have one piece guides or two piece?

the old valve guides were two piece but the new ones are 1 the stem configuration is all different
i found no such part in the old valves and no mention of them in the book thank you for your response

Follow Ups:

Post a Followup