Posted by JMS/.MN on March 23, 2015 at 21:33:18 from (209.237.125.241):
In Reply to: Raising Garage posted by in-too-deep on March 23, 2015 at 12:21:02:
Wondering if the forklifts have enough capacity? Figure out a materials list, do the math to figure out what the garage weighs. I wouldn"t use the handyman jacks, retaining boxes or not- they"re shaky support. I raised a corn crib with them once. Definitely need to remove the sill and scab to the uprights to maintain sidewall strength. Check with a building mover if you can borrow some cribbing to support the building while doing the walls. Concrete walls are a good idea.
FWIW, I"ve moved a single car garage with a 3020 with loader on the front, bale fork and crossmember on the rear....around the yard a couple times, and half mile down the road to my son"s place.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
