Bryant, I can offer my experience with a JD 4100 subcompact tractor that my parents purchased in 2000. We had a IH H sized tractor growing up and I presently have a Ferguson TO-20 and MF135. The 4100 has fluid in all the tires and the wheels are turned out as wide as they will go. Even at that it is not as stable as even the IH H on a slope because of the narrow wheelbase. These tractors have a roll bar and seat belt. Be sure and use them. I have had the uphill wheels start to lift off the ground on a slope that would not have been a problem for the other tractors mentioned. As a reminder, I attended an auction last year for a family that lost their father who turned over a similar sized Kubota as the JD 4100 while mowing on not that steep a slope and was killed. They had removed the roll bar so he could mow under tree limbs easier. They are great little tractors but you have to be very careful on slopes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.