You've got to remember, if you tee into a line, that valve will be subject to the highest pressure that the line sees, not just what the attachment your running through it will take.
In other words if you were to bottom out a cylinder on another attachment and system pressure built to 1800 psi, you just went three times what the valve is rated at. At that high of a pressure, the potential for a high pressure stream, or for the cast valve to simply explode is too great to chance, in my opinion.
Your best bet would be to simply get a valve rated for hydraulic service from somewhere like Surplus Center. As you can see, a 3/8 valve, which would more than likely allow plenty of flow for your application, isn't but $18.95.
This would be your safest way, along with being the RIGHT way to do what you need.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Self-Starting Tractor - McCormick 10-20 - by Francis J. Robinson. I remember it very clearly even though it was almost 50 years ago and I was only about seven years old. My Dad had purchased a new Ford-Ferguson tractor and basic set of implements when he started farming just about the beginning of W.W.II. It was considered a pretty nice outfit for their 70 acre central Indiana grain and livestock farm. Dad spent several years during the war testing aircraft engines at Allison Engineering in Indianapolis working seven days a week on a twelve hour night sh
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
