Posted by andy r on March 17, 2015 at 21:00:01 from (75.91.149.15):
I have two hydraulic outlets on my planter tractor. I use one to lift the planter and one for the markers. I also have an overhead auger to deliver dry fertilizer to 4 hoppers. Rather than disconnecting the hydraulic lines for the markers and attaching the auger orbit motor hoses every time I fill the hoppers I would like to put a tee in the marker line. At the tee I would put a ball valve in one hose on each line - one going to the markers and one going to the orbit motor. I could easily close one and open the other. Has anyone else ever used a plumbing ball valve in a hydraulic application? The ball valves are only rated at 600 psi. They are heavy brass. What gives? The casting, the stem seal, or the nylon insert around the ball inside? It probably doesn't take many psi to move the markers or to power the auger. Is it worth a try. I have a hydraulic multiplier (splitter), but I have enough electronics on the planter and tractor now. I want this to be simple. Any other ideas? Thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.