Posted by Chris Jones on March 13, 2015 at 18:46:52 from (65.188.217.236):
In Reply to: Seized up engine posted by Why Worry on March 13, 2015 at 15:06:56:
I doubt there is any miracle fixer that can be poured in. My father didn't check the oil in his tiller before using it and apparently it uses it and it was almost nothing in there. He called me to say it quite while idling at the end of the row and he though the electric starter was broke. I couldn't pull the pull start rope either. I noticed the oil level. It was seized. Not much to loose at that point in trying a quick "fix". I put some oil in the crankcase and a few squirts in via the spark plug hole. I tipped and turned the tiller as best I could to coat the inside of the engine. I then took a 1 foot bar and a socket on the flywheel nut and pulled first one way then the other back and forth. It took some force to get movement but finally I felt it free up. After a few turns I was able to use an air ratchet to turn it for a few minutes until it felt about the same resistance to turning through out the complete revolution and I could spin it sufficiently to start it with the pull starter. I fired it up and it's been fine since. Changing the oil again soon isn't a bad idea either as it surely has to "hone" itself back in as it resumes running and might just deposit more metal in the oil during that time. I told him it most surely would burn oil now and I couldn't guarantee how long it would last--so far so good.
I can't blame anyone for forgetting. I've done it too though thankfully nothing has seized before I remembered. Worst I've had happen is increased oil usage and smoke afterwards. I'm a bit paranoid about doing it again and do things like put the new oil containers in the seat or sit them on top the engine immediately following opening the oil drain now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
