Posted by Determined on February 18, 2015 at 11:53:05 from (216.130.212.90):
Has anyone ever seen a chewed up ring gear with mushroomed over teeth, like the ones commonly seen on old tractors with 6 volt systems?
Some of them are messed up so bad that even a new drive gear has trouble engaging and quickly fails.
Most often seen on a neglected starter with poor connections that can not deliver enough power to crisply engage the drive and usually associated with a loose starter, excessive play in bearings or bushings, bent armature shaft, corrosion etc.
Often when you hook up one of those starters to a 12 volt battery and correct any of the problems listed above it does not take long for that firm engaging drive to clean up all of those burrs and create a real nice pattern when you check the mesh to the ring gear, this is assuming the starter was properly installed and shimmed as required.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.