Posted by David G on February 14, 2015 at 15:23:14 from (204.12.184.93):
Daughter's Corolla has a vibration when cold and in gear that I am working on.
There was only about 1/16" clearance between the exhaust pipe and the cross member, I changed out the passenger motor mount, and there is now about 3/16" clearance.
I checked valve clearance today, it is at the minimum value on most of the valves, but none under minimum. The tolerance is about .004, from minimum to maximum, so I would like to shim then a couple of thousands, but do not think it is worth the trouble. I was going to put it back together, but am out of sealer. It only has a few thousand on it since changing timing belt, the sealer in the corners was hard as a rock, I am not happy about that.
I will put the valve cover back on tomorrow, once I get sealer and see how it sounds. I still want to check the timing, because it sounds a tad slow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
