You have a lot of options, the existing shop and site and all the others you mentioned.
I would "value engineer" each, weigh in the advantages such as the site and so on, compare and then make a decision. There is nothing worse than a building that just does not function for an owners needs, let alone having drainage and site issues.
If the existing building site is ideal, you can improve the conditions of the site to perform as needed, then you can consider what may be salvageable, compare the labor to salvage against new construction costs. My point is, maybe you take a spread sheet, fill in all the blanks and see what pencils out. These are simple buildings with specific features you may want or need, nothing complicated, so you should be able to "pencil in" everything conclusive, then see what makes the most sense.
Ideally, you want that home and shop now, so you can make use of it, however none of us (or that I know live in anything remotely ideal LOL!)
So given its 24'x 24', common type of wood frame construction, you need to do a lot of work under it, is it worth the labor to salvage? That thing could be down very quickly and the remedial work to the site commenced immediately, and the only loss is the value of 30 year old lumber, of how much is compromised, vs new material and what, a few days or less, (depending on how its done) of labor to erect/frame it. That labor will easily cancel out with the labor to salvage, shore up, reinforce, jack, and then you still have to work around it. Concrete is already a loss, site has to be corrected anyway, shingles are done, as well as the doors, at a glance it would make sense to start from new.
If the existing location works with improvements, it may very well make sense to look at the obvious.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
