Posted by Dick2 on January 19, 2015 at 22:21:08 from (75.172.225.172):
In Reply to: Plowing posted by Ted in NE-OH on January 19, 2015 at 17:20:58:
I think most of the horse drawn plows were 2-bottoms of 12" shares for a total of 24" cut.
The standard at the time was to drive the horse 20 miles in a day; that was that limit for most horses. If you know tha length of the field, you can calculate the acres.
Knew a fellow that worked on a large Bonanza farm in ND. The hired men would leave the headquarters with a team and 2-bottom plow and plow 5 miles south and then 5 miles back north. They made 1 round in the morning and 1 round in the afternoon and had their 20 miles in for the day. It took a lot of horses, small equipment and hired men to farm those big farms at that time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
