Posted by tritowns on January 16, 2015 at 06:24:58 from (162.251.197.122):
In Reply to: gasified Case 310 posted by JIMKS on January 13, 2015 at 07:29:21:
Quoting Removed, click Modern View to see
this is a picture of the drop leg carb that I use. wood gas comes in one side, air the other ( a quarter turn valve is mounted near the operators seat so it can be manipulated) mixes and then goes down to a t where a quarter turn valve has been modified so that a linkage from the tractors govenor can move it freely. then I have another quarter turn valve so that the whole woodgas side can be separated from the system and gasoline used. I built a woodgas inlet plenum and the regular updraft carb mounts to it. hope that makes sense. In the picture I have a carb block off plate installed but I usually just use another vavle between the air cleaner and the air inlet of the gas carb to shut that side of the system down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
