Posted by Steve@Advance on January 12, 2015 at 19:50:05 from (107.203.134.67):
In Reply to: Rear axle shims posted by Fordred8n on January 12, 2015 at 13:30:35:
The shims are what determines the bearing preload. There is no specific number, you add or take shims away to preload the bearings. You want the bearings to have a very slight preload, no endplay.
A shop manual can explain it better than I can, it would be a valuable investment!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
