Posted by RodInNS on December 01, 2014 at 06:56:56 from (216.118.158.123):
In Reply to: Recovery after ether? posted by GMSTAG on November 30, 2014 at 20:50:07:
Ether is not a problem if it's used properly.... that can be a BIG IF... I've never had a problem with ether myself but I have seen engines with bent rods and piston lands blown off because of it. I've always tried to have the engine rolling before I spray and only use the smallest burst I can get from the can. If it doesn't fire in 3-4 seconds then I'll give it another little burst. If it's extremely cold... then mabey a little more. My own belief is that the real problems start when you get a cold engine that won't start... and you crank it and load the piston crowns up with raw fuel... then you feed ether to it because it won't fire... and a big blast of ether WILL make fire... and it ignites that big fuel load that you've already got in the chamber... and then it knocks like hell, bends rods and breaks pistons and rings. Ether, in and of itself, in the absence of another fuel... is not a problem in any way.
As far as the idea of an engine being addicted to ether... that's nonsense. If an engine won't start without ether it's either worn out or already severely damaged from ether. Rebuilding is the only corrective action at that point.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Case Farm Equipment - by Jeremy Sweeten. My name is Jeremy Sweeten and I am currently a junior at Purdue University. I am takin a dual major in Agriculture Systems Management and Agronomy. I am from North Central Indiana, Miami County to be exact. My dad teaches for Marion Community School Systems an outdoor lab called Asherwood. We live there to manage the place. They just happen to have a Case 311 with a Triple Range transmission. I grew up mowing, pushing snow, and hauling maple sap with it. In 1986 my parents bought an old,
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
