Posted by George Marsh on November 13, 2014 at 14:31:06 from (50.127.10.23):
Many have asked what is the best drill bit sharpener? Many, myself included, sharpen bits by hand using a grinder.
I have a cheapie HF saw blade sharpener. For the money it does a great job on blades. One time, I tried using it to sharpen a drill bit. The diamond wheel does a great job removing metal from bits too. It like sands it, no sparks, little heat, produces dust like metal particles.
Well, I'm too cheap to buy a sharpener, so I made one out of my HF saw blade sharpener. I used a sharpie to paint the end of a new 1/2 drill bit. Then I touched the new bit to diamond wheel. Looked at where the sharpie was removed and made adjustments so all the shapie was removed. After a few attempts, I got it right.
It doesn't take any time to sharpen bits. Tested them out on drill press. I turned out many long cork screw like pieces of metal.
Actual cost, NOTHING, just a little time.
So much for eyeballing and sharping a bit with a grinder. It became apparent to me just what a poor job I used to do. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
