Posted by George Marsh on November 13, 2014 at 15:02:58 from (50.127.10.23):
In Reply to: Re: Drill bit sharpener posted by Steve@Advance on November 13, 2014 at 14:50:45:
Steve, When I purchased the sharpener, I made sure I could get replacement diamond wheels. My HF had them. Don't remember how much. The wheel in pic is the original. It has 2 sides. I've sharpened many blades, today many bits and still using the same side.
I think the arbor size is much smaller than a 5/8 inch arbor on a grinder.
I don't recall what I paid for sharpener, it was on sale and I had 20% off coupon. I think it was under $50.
I like to use dewalt 10 inch old school molly steel blades without carbide tips. Very easy to sharpen, around $10, very thin blade, uses less hp, rips through red oak like it cutting soft pine. The key to sharpening blades and bits is using a sharpie. It shows you when you have removed enough. George
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
