I straightened out a small barn with a steel cable and chain hoist. You need to be careful as a warped old beam will not bend back, but crack. If the lean is due to lose joints, it is much easier to straighten it out then bolt or brace them solid again. I have saved all the buildings on our place and am very happy I did. It is alot of work and sometimes seems harder than starting all over, but it also gives alot of satisfaction. In our case, it saved money as we replaced roofs with new metal and generally used old lumber for the wood repairs. Here in the east, a barn is doomed if the roof starts leaking. So, we did the roofs first and worked down. We saved 4 buildings on our place and taxes stayed the same. We put up a new pole barn and taxes went up immediately. You decide.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Generators - by Chris Pratt. As a companion to the articles on three-brush and two-brush generators, it seemed fitting that we should provide our readers with a description of how a generator works in lay terms. The difficulty with all those "theory of operation" texts is that they border on principles of electricity or physics and such. Since I know nothing of either, you will have to put up with looking at the common sense side of how generators work which means we "
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
