Posted by donjr on September 17, 2014 at 07:50:57 from (71.246.64.80):
In Reply to: 3pt or pull type posted by young tractor on September 17, 2014 at 07:07:20:
For what little chisel plowing I did, everyone around here recommended a 3 point. We refer to them as really good rock finders, but the pull type were sheer pull power where the three point chisels transfer some of the weight to the tractor in tougher going. I had a 7 shank and it needed about 10 hp per shank for a pull type.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
