Posted by Bob on August 31, 2014 at 18:51:31 from (75.235.115.251):
In Reply to: Kholer Generator posted by Mike Kork on August 31, 2014 at 12:56:47:
Unless you can tap into the flow from the oil pump and route it through a filter (with the appropriate relief valves) and back to the main oil gallery, you can simply use a bypass filter, which filters a small portion of the oil pump's output, and returns it to the oil pan.
WIX has a nice filter head, and and a few filters of different sizes to go with it.
The nice feature is that the restrictor orifice is in the FILTER and gets replaced every time, eliminating the long-term possibility of a clogged orifice resulting in no oil filtration
Go to the link below, and click on "24755" for more info.
(I have installed them on quite a number of older engines over the years, and they are reasonably priced.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.