Posted by John T on August 21, 2014 at 15:37:20 from (216.249.72.121):
THANKS TO ALL, and YES the procedure in the Manual (also posted below, thanks) I TRIED 10 TIMES TO NO AVAIL GRRRRRRRRRRRRRRR
After trying the factory methods,,,,,,,,,, after 3 brands of oil and spray lube and beating and cussing,,,,,,,,after 2 or 3 rest and cool off breaks and mowing the grass,,,,,,,,I GOT MAD and got it lowered just to where it stops AND GAVE HER A FEW MORE UPWARDS HAMMER BEATS and yayyyyyyyyyyyyyyyyyyyy she released
AND SHE WILL NEVER STICK AGAIN the cable and all else was actually good n clean n not rusted, it was ONLY the catch thingy that was sticking BUT IT WILL NEVER AGAIN CUZ I GROUND THE *&^%$#@! CATCH THINGY OFF
Now the cable winds up and holds tight but for safety I'm using two 1/4 chains with S Hooks that will hold it in place even if the cable were to break or release AND THATS MY METHOD AND IMA STICKIN TO IT
I wanted to get it done while I was all hot n sweaty and nasty n dirty as a hog because tomorrow we have to pick up the Architect daughter flying in from Texas and I didnt wanna mess with it in the morning. So now a long hot shower, wife is fixin a steak dinner THEN ITS MILLER TIME YAYYYYYYYYYYYYYYYYYYYYYYYY And as my old buddy used to say I DESERVE IT LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
