Posted by ss55 on July 30, 2014 at 18:50:31 from (50.81.112.224):
In Reply to: Lock Washers????? posted by Jiles on July 30, 2014 at 08:35:48:
A few shops still specify split lock washers, most haven't for decades. I will still use split lock washers where pieces must be finely adjusted into position by hand. A lock washer maintains some bolt tension and some friction between the joined parts. That makes it easier to just crack the bolts loose and tap the joint around without it being completely loose. Jack screws on/or dial indicators help too.
I'm under the impression split lock washers were most useful when wood was still used in machines. As the wood under a bolt softened or compressed, tension on bolts could be quickly lost. A split lock washer is a short spring with 1/32 or more travel, it would maintain some tension on the bolt as the wood compressed.
On farm machinery made of soft steel, where components bend and flex, and the fasteners are all softer bolts, lock washers can work. Between hardened steel and grade 8 bolts, lock washers are about useless.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.