I'm far from an expert but I have refurbished 8 running gears over the past 8 years as I build one parade wagon a year. What I have found is that the front axle - with or without a bolster - is at least as high off the ground as the rear axle and in a few cases, the front has been an inch or so higher than the rear. In your case it looks to me like someone in the past has removed the front bolster and welded the standards to the axle. All of the bolsters on my gears have been bolted to the axles. Your reference to "cross bar on top of the front axle" is the bolster which your wagon has none. The "holders for the 4x6's" are the standards which are bolted to the bolster. Yours are welded. Do the front and rear standards line up parallel with the reach? If not and if this gear was in my yard and assuming the rear axle/bolster/standards are correct, I would take my angle grinder and cut the front standards off, have new ones made (any good welding shop that bends metal can do it) that you can bolt to the axle. Lay a 4x4, ripped to meet the height of the rear bolster, on the front axle between the new standards and drill 2 vertical holes through the 4x4 and axle near both ends and bolt the 4x4 on to the axle. Now you have a level plane to lay your 2 main beams and they are supported at both ends by the standards. On my parade wagons I bolt the main beams to the rear standards and put chains around the beams/front standards. You will find a variety of methods for attaching the beams to the standards but this is what I use.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning Up Your Tractor: The Battery - by Curtis Von Fange. Buried somewhere beneath the sheetmetal, under the gas tank, or stuffed in front of the radiator is the battery. This elusive and neglected component of the tractor is the hardest to get to when it is dead and in need of a jump. But usually, the storage battery is a storehouse of electrical energy waiting to be released a the flick of a switch. A few maintenance tips and periodic cleaning will keep it charged for the duration of its life span. The battery is made up of a number of lead bas
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
