Here are my experiences. I had two 2nd gen (one 97, one 98) 3500 ext cab, 4x4, dual wheel dodge trucks, both diesel, one standard one auto. I got rid of them for the heaviest spec 2012 3500 I could get. Cab was great, fuel economy was not as bad as I expected (it seemed for the amount of work done you burned the same fuel, it was just a lot faster, instead of clearing the top of a hill and being glad you made it you've got to watch for the cops). Great truck, however in the 15 years they improved their truck so much it was too much truck for my need, could never get it to squat with a load or get my trailer to ride right with it. I traded it on a 2013 2500 with manual transmission and love it. I've hauled 15000lbs and it doesn't bat an eye. Light years ahead of the 12 valve in many ways, but when it's dead and gone I'm sure the '97 12v that my girlfriend has will still be rattling along.
The '06 will be a good step up power wise and is still pre-emissions. They seem to be pretty sought after. I personally would stay away from 07.5 to 2010 as they were the first years for emissions and there were problems. I didn't have any emissions problems with the 2012, which didn't have fluid. All 13's have fluid and so far so good - getter better fuel mileage with it. Deleting, while possible, gets more difficult with the newer trucks. Exhaust brake is wonderful, especially with a manual.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
