Posted by fixerupper on June 18, 2014 at 20:08:42 from (100.42.82.100):
In Reply to: oil problems posted by Lacorya on June 18, 2014 at 18:56:06:
A sender off a Massey may or may not work. Most older senders have 1/8" male pipe threads but your Deutz is German, meaning metric fittings so I don't know if the Massey sender will screw into the Deutz hole. If it fits, screw the Massey sender in and see what happens. Personally, I would mount a manual gauge in a location where you can see it and forget the light. On one of my tractors I mounted a manual oil gauge in front of the lower right side front cab window, outside the cab in a place where I can glance down and check it once in awhile just to make me feel good. The electric gauge scared the he!! out of me once when it lost connection and went to zero while I was plowing. The pressure was still there but the gauge didn't show it. That's when the manual gauge went in front of the cab window. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
